10. Install the universal media bay .
11. Connect the power and data cables .
12. Install the access panel .
13. Slide the server into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server .
Installing a midplane drive cageInstalling a midplane drive cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that the components included with the hardware option kit are available.
About this taskAbout this task
A 1U performance heatsink is required for each processor when installing this option.
ProcedureProcedure
1. Power down the server .
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
To Next Page
Loading...
