8. Connect the cables .
9. Install the access panel .
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server .
Installing a PCIe network adapterInstalling a PCIe network adapter
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the power cord to
remove power from the server. The front panel Power On/Standby button does not shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
CAUTION:CAUTION: To prevent improper cooling or thermal damage, do not operate the server unless all PCI slots have either an
expansion slot cover or an expansion board installed.
To install the component:
ProcedureProcedure
1. Power down the server .
2. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
