9. Route the cables through the opening.
10. Install the universal media bay.
11. Connect the cables .
12. Install the access panel .
13. Slide the server into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server .
ResultsResults
The installation is complete.
Installing the optical disc drive in the SFF universal media bayInstalling the optical disc drive in the SFF universal media bay
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
Phillips No. 1 screwdriver
ProcedureProcedure
1. Power down the server .
2. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
