Close the chassisClose the chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Close the chassis:
a. Ensure that all cables are secured by cable clamps or metal tabs.
b. Pivot the upper half of the chassis inward to close the chassis.
To Next Page
Loading...
