SubtopicsSubtopics
Safety considerationsSafety considerations
Preparation proceduresPreparation procedures
Removing and replacing the front bezelRemoving and replacing the front bezel
Drive replacementDrive replacement
Removing and replacing the four-bay drive cable assemblyRemoving and replacing the four-bay drive cable assembly
Removing and replacing the ambient temperature sensor cableRemoving and replacing the ambient temperature sensor cable
Removing and replacing a DIMMRemoving and replacing a DIMM
Removing and replacing the fanRemoving and replacing the fan
Heatsink replacementHeatsink replacement
Processor replacementProcessor replacement
Removing and replacing an expansion cardRemoving and replacing an expansion card
Removing and replacing the iLO-M.2-serial moduleRemoving and replacing the iLO-M.2-serial module
Removing and replacing the serial port cableRemoving and replacing the serial port cable
System board replacementSystem board replacement
Removing and replacing the power distribution boardRemoving and replacing the power distribution board
System battery replacementSystem battery replacement
Safety considerationsSafety considerations
Before performing service procedures, review all the safety information.
SubtopicsSubtopics
Electrostatic dischargeElectrostatic discharge
Symbols on equipmentSymbols on equipment
Server warnings and cautionsServer warnings and cautions
Electrostatic dischargeElectrostatic discharge
Be aware of the precautions you must follow when setting up the system or handling components. A discharge of static electricity from a
finger or other conductor may damage system boards or other static-sensitive devices. This type of damage may reduce the life expectancy
of the system or component.
To prevent electrostatic damage:
Avoid hand contact by transporting and storing products in static-safe containers.
Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.
Place parts on a grounded surface before removing them from their containers.
Avoid touching pins, leads, or circuitry.
To Next Page
Loading...
