Powering up and setting up iLO4
Powering up the HPE StoreOnce 5500 System
If the StoreOnce system has not yet been powered on, as described in the appropriate Start Here poster,
or if you need to configure iLO 4 from a direct connection, perform the following steps.
Procedure
1. Perform a final check to ensure all cables are connected correctly and securely:
2. Server unit
a. Two power cables to the server
b. Keyboard and monitor cables
c. Network cable to LAN port 1
d. Network cable to iLO port
e. Optional hardware — see the StoreOnce Optional Hardware Installation and Configuration Guide
3. Disk enclosure(s)
a. Four power cables to the disk enclosure
b. Two 2 m SAS cables from the disk enclosure to the first RAID controller card (slot 2)
c. Two 0.5 m SAS cables between the drawers on the disk enclosure
NOTE:
See Hardware overview reference section on page 68 for cabling examples.
4. Power on all installed disk enclosures first. You may need to hold down the power on button (1) on the
rear of each unit for up to 30 seconds. Look at the LEDs on the I/O modules and wait until the Green
Status LED (3) remains on, and the Locate LED (2) and the Fault LED (4) are both off.
20 Powering up and setting up iLO4
To Next Page
Loading...
