HPE StoreOnce 5100

Table 10: SNMP Agent configuration parameters
Name Description
System description This is the description for the StoreOnce system configured for
the agent.
SNMP version This is the SNMP version of the agent (version 1, 2, or 3). The
default is 2.
State This shows the state of the agent (off, on).
Port This is the port location of the agent.
Encrypt Passwords and
Communities
This defines whether encryption for passwords and communities
is on or off.
System Contact This is the contact information for the system administrator,
which may be a name, email address, or phone number. A
maximum of 20 characters is allowed.
System Location This is the physical location of the StoreOnce appliance. A
maximum of 20 characters is allowed.
Read Community This defines the SNMP Read Community string. The default is
public. If you want to restrict read access, enter a string of up to
20 characters. This string acts as a password for Read access
and must be manually configured in the management
application so that it can access events.
System Object ID The SNMP agent unique System Object ID. SNMP agents
(running on a StoreOnce Device) supporting HP-
httpManageable-MIB must provide a unique System Object ID.
This ID is used by network management entities to determine
the monitoring capabilities of a device.
Engine ID This optional device-specific parameter can be provided to an
SNMP version 3 trap listener device such as HP SIM (or any
third party tool) to listen to version 3 traps coming from the
device.
Allow non-V3 read requests This optional parameter can be provided during version 3
configuration. If the value is yes, versions 1 and 2 are supported
along with version 3. If the value is no, only version 3 is
supported. If this parameter is not configured, only version 3 will
be supported.
48 Setting up SNMP (Simple Network Management Protocol)