HPE StoreOnce 5200

1
2
3
c. Attach the rear hold down brackets by sliding the tab with the arrow pointed forward into the
corresponding slot on the left and right side of the rear of the chassis.
1
2
5. Use the black headed thumb screw to secure the front of the enclosure tightly to the rail.
6. Connect the storage enclosure cables.
The supplied cables are labeled on both ends with the following convention.
• N = Node (server node)
• S = Slot
• P = Port
• J = JBOD
• I = I/O module
HPE StoreOnce 3640 System 31