5. Review the compute module front panel LEDs to determine the compute module status. For more
information on the compute module LEDs, see "Component identification."
To remove the component, reverse the installation procedure.
CAUTION:
Before removing the compute module, be sure to verify that the compute module is in standby mode by
observing that the system power LED is amber. Also, verify that the UID LED is not flashing blue.
Removing and replacing an access panel
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Press the access panel release button.
32 Removing and replacing an access panel
To Next Page
Loading...
