NOTE:
If you are installing a Type C mezzanine option card into mezzanine slot 2 of the compute module and the
heatsink has an airflow baffle installed on it, then remove it. If the heatsink does not have an airflow baffle,
then mezzanine 2 cannot be used. If a Type C mezzanine option card is not in mezzanine slot 2, leave the
airflow baffle attached to the heatsink.
To replace the component, reverse the removal procedure.
Removing and replacing a heatsink blank
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
38 Removing and replacing a heatsink blank
To Next Page
Loading...
