KP806 User Manual
Rev.1.0
1) Please only use the power adapter are recommended by supplied or equivalent products;
2) When disconnecting the power adapter plug, handhold plug connector housing, to avoid the
pulling on the cable in force;
3) Avoid drag the power adapter cable, otherwise it will damage the cables, causing fire and shock;
4) Avoid put power adapter around a heating device, otherwise the cable may melt, causing fire and
shock;
5)If you do not use the printer in a long time, disconnect the power supply of printer power adapter.
3.6 Interface Cable Connection
1) Make sure the printer's power switch is turned off;
2) Put the interface cable into the matched interface and fixed with screws (or spring) on the plug;
3) Connect the other end of the interface cable to the host.
3.7 Print Test
3.7.1 Print Self-Test
1) Make sure the printer has been installed roll paper and turn off the top cover.
2) Make sure the printer has linked power.
3) Make sure the printer power off.
4) Press and hold FEED button, then turn on power switch, the printer will print out self-test page.
3.7.2 Printing of Windows Driver Program
1) Install the Windows Driver program. (Please refer to the Windows Driver Manual).
2) Please set the “Interface” as the type you use.
3) Use the Windows Driver Program to print out the “Print Test Page”.
To Next Page
Loading...
Need help?
General
