TP801/TP805/TP806 User Manual
www.hprt.com 16
4 Printer packing
4.1 Open packing
When opening the package, according to the packing list to check if items are missing
or damaged, if so, please contact the dealer or manufacturer.
4.2 Choice installation site and direction of printer
1) Install the printer on a flat, stable place; recommend to install it at horizontal
line, angle of inclination should not exceed ± 10 °(paper feed direction)if tilt
install printer, it does not allow to tilt by other direction.
2) Keep printer far away from source of water；
3) Avoid the printer on place where it is vibration and shock
4) Ensure printer ground connect is sate；
5) When the printer is at operation and maintenance, it is recommended to
retain the space as below to ensure the printer can work in reliability and ease
of operation.
4.3 Connect the printer power adaptor
1) Make sure the printer's power switch is turned off;
2) Put the cable plug of power adapter facing up at flat side, insert the rear of
the printer power connector;
3) Turn the power adapter input power;
4) Pay attention about disconnecting or connect the AC adapter at right method,
or likely to cause damage.
The plug of power adapter is designed in a switch type, when accessing power
adapter and uttered the voice "click", it means the connected socket switch is locked
the adapter connect well, otherwise please connect again .
When pull out the adapter, please pinch the shell of power adaptor and pull the
switch up, when the switch is fully opened then pull out the power adapter.
Don’t put forth your strength to pull the plug by squeeze at any of place of power
adaptor .Because, it is more difficult to pull it out and easy to damage the cable.
To Next Page
Loading...
Need help?
General
