TP80BE User Manual
7 PRINTER CLEANING AND MAINTENANCE
Print quality might be degraded by dust, foreign substance, adhesive substance, or other
pollution materials stuck in the printer head or inside the printer.
When dirty, clean the print head as follows:
※ CAUTION
Make sure to turn off the printer prior to cleaning.
As the print head gets hot during printing, intending to clean the print head, turn the
printer off and wait approximately 2~3 minutes before commencement.
When cleaning the print head, take care not to touch the heated portion of the print head.
Print Head is susceptible to damage from static electricity, etc.
Take care not to allow the print head become scratched and/or damaged in any way.
7.1 Cleaning Head
1) Open the Printer Cover and then use the cleaning pen to clean the head in the direction
from the center of the head to the edges.
2) After cleaning the head, do not use the printer until the alcohol used for cleaning evaporates
completely (1~2 min) and the printer has completely dried.
7.2 Cleaning Sensors, Roller and/or Paper Path
1) Open the printer cover and then remove the paper.
2) Remove any dust or foreign substance using dry cloth or cotton swab.
3) Soak the cloth or cotton swab in alcohol for medical use and use it to remove adhesive
foreign substances or other pollution materials.
4) After cleaning the parts, do not use the printer until the alcohol evaporates completely (1~2
min) and the printer has completely dried.
※ Clean the parts whenever print quality or paper detection degraded.
To Previous Page
Loading...
Need help?
General
