Tools and Calendar 194
5. When you see the name of your headset in the Available Devices section, touch the
name. Your phone pairs with the headset and the headset connection status is displayed
in the Paired Devices section.
Note: If automatic pairing fails, enter the passcode supplied with your headset.
The pairing and connection status is displayed below the hands-free headset or car kit name in
the Bluetooth phones section. When the Bluetooth headset or car kit is connected to your
phone, the Bluetooth connected icon is displayed in the status bar.
Reconnect a Headset or Car Kit
Normally, you can easily reconnect your headset by switching on Bluetooth on your phone, and
then turning on the headset. However, you might have to connect manually if your headset has
been used with another Bluetooth device.
Important: Make sure that the headset is discoverable. Refer to the headset manual for details.
1. With two fingers, swipe down from the status bar to open Quick Settings.
2. Touch the BLUETOOTH tile to turn Bluetooth on.
3. Touch below the BLUETOOTH tile to open the Bluetooth screen.
4. Touch the headset’s name in the Paired Devices section.
5. If prompted to enter a passcode, try 0000 or 1234, or consult the headset/car kit
documentation to find the passcode.
If you still cannot reconnect to the headset or car kit, follow the instructions in Disconnect From
a Bluetooth Device, and then follow the steps in Connect a Bluetooth Headset or Car Kit.
Disconnect From a Bluetooth Device
If you do not need to use Bluetooth at any given point, you can disconnect and unpair your
phone from a Bluetooth device.
1. With two fingers, swipe down from the status bar to open Quick Settings.
2. Touch the BLUETOOTH tile to turn Bluetooth on.
3. Touch below the BLUETOOTH tile to open the Bluetooth screen.
4. In the Paired Devices section, touch next to the device to unpair.
5. Touch Unpair.
Note: Touch the name of the device to reconnect it.
To Next Page
Loading...
