Step 6 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the VLANIF interface is configured.
After assigning an IP address to the VLANIF interface, you can run the stelnet command to log
in to a management industrial switch router to manage attached devices.
----End
Checking the Configuration
l Run the display vlan command to check information about the mVLAN. The command
output shows information about the mVLAN in the line started with an asterisk sign (*).
3.7 Configuration Examples
This section provides several configuration examples of VLANs including networking
requirements, configuration roadmap, and configuration procedure.
3.7.1 Example for Configuring Interface-based VLAN Assignment
Networking Requirements
An enterprise requires departments in charge of the same service to communicate with each
other while isolating departments in charge of different services.
As shown in Figure 3-20, an enterprise has four departments. Department 1 is connected to
RouterA, which is connected to Ethernet 2/0/1 of the Router. Department 2 is connected to
RouterB, which is connected to Ethernet 2/0/2 of the Router. Department 3 is connected to
RouterC, which is connected to Ethernet 2/0/3 of the Router. Department 4 is connected to
RouterD, which is connected to Ethernet 2/0/4 of the Router. The requirements are as follows:
l Department 1 and Department 2 in VLAN 2 are isolated from Department 3 and Department
4 in VLAN 3.
l Department 1 and Department 2 in VLAN 2 can communicate with each other.
l Department 3 and Department 4 in VLAN 3 can communicate with each other.
Figure 3-20 Network diagram of interface-based VLAN assignment
Eth2/0/1
RouterA
Eth2/0/2 Eth2/0/3
Eth2/0/4
Department 1
VLAN2 VLAN3
RouterB RouterC
RouterD
Router
Department 2 Department 3 Department 4
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching 3 VLAN Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
104
To Next Page
Loading...
