Huawei AR530 Series - Configuration Task Summary

Figure 2-9 Link aggregation networking
Core
Network
UPE
PE-AGG
IPTV
DATA
…………
Eth-Trunk 1
VoIP
You can determine the working mode for the Eth-Trunk according to the following situations:
l If devices at both ends of the Eth-Trunk support LACP, the LACP mode is recommended.
l If the device at either end of the Eth-Trunk does not support LACP, you must use the manual
load balancing mode.
QoS can be implemented on an Eth-Trunk as a common interface. At both ends (UPE and PE-
AGG) of Eth-Trunk 1, traffic shaping, congestion management, and congestion avoidance can
be performed for outgoing traffic, ensuring that packets of high priorities are sent in a timely
manner.
2.4 Configuration Task Summary
The device supports the manual load balancing mode and Link Aggregation Control Protocol
(LACP) mode.
Table 2-1 lists the link aggregation configuration tasks.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching 2 Link Aggregation Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
40