Huawei AR530 Series - Configuration Examples

Procedure
Step 1 Run the reset garp statistics [ interface { interface-type interface-number [ to interface-type
interface-number ] }&<1-10> ] command in the user view to clear GARP statistics on the
specified interfaces.
----End
5.7 Configuration Examples
This section provides a configuration example for GVRP.
5.7.1 Example for Configuring GVRP
Networking Requirements
As shown in Figure 5-10, company A, a branch of company A, and company B are connected
using switches. To implement dynamic VLAN registration, enable GVRP. The branch of
company A can communicate with the headquarters using RouterA and RouterB. Company B
can communicate with company A using RouterB and RouterC. Interfaces connected to
company A allow only the VLAN to which company B belongs to pass.
Figure 5-10 Networking diagram of GVRP configuration
RouterA
RouterB
RouterC
Branch of
company A
Company A
Company B
Eth2/0/1
Eth2/0/1
Eth2/0/2
Eth2/0/1
Eth2/0/2
Eth2/0/2
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable GVRP to implement dynamic VLAN registration.
2. Configure GVRP on all switche devices of company A and set the registration mode to
normal for the interfaces to simplify configurations.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
5 GVRP Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
157