Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Step 3 Run:
bridging { ip | others } disable
The bridge group is disabled from bridging specified protocol packets.
By default, a bridge group bridges all protocol packets.
----End
9.6.3.5 (Optional) Configuring VLAN ID Transparent Transmission
Context
By default, an outbound interface of a bridge group removes the VLAN IDs of the packets to
be sent out. After VLAN ID transparent transmission is configured on an outbound interface of
a bridge group, the outbound interface does not remove the VLAN IDs of the packets to be sent
out.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
bridge vlan-transmit enable
VLAN ID transparent transmission is enabled.
NOTE
l VLANIF interfaces do not support VLAN ID transparent transmission.
l It is not recommended to use the VLAN ID transparent transmission for sub-interfaces.
Step 4 Run:
quit
Return to the system view.
----End
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
371
To Next Page
Loading...
