Huawei AR530 Series - Optional) Setting the Registration Mode for a GVRP Interface

The interface is added to the specified VLANs.
Step 6 Run:
gvrp
GVRP is enabled on the interface.
By default, GVRP is disabled globally and on each interface.
NOTE
The device supports a maximum of 256 dynamic VLANs when using default GARP timers. When the
recommended GARP timer settings are used, the device supports a maximum of 4094 dynamic VLANs.
----End
5.5.2 (Optional) Setting the Registration Mode for a GVRP Interface
Context
A GVRP interface supports three registration modes:
l Normal: In this mode, the GVRP interface can dynamically register and deregister VLANs,
and transmit dynamic VLAN registration information and static VLAN registration
information.
l Fixed: In this mode, the GVRP interface is disabled from dynamically registering and
deregistering VLANs and can transmit only the static VLAN registration information. If
the registration mode is set to fixed for a trunk interface, the interface allows only the
manually configured VLANs to pass even if it is configured to allow all the VLANs to
pass.
l Forbidden: In this mode, the GVRP interface is disabled from dynamically registering and
deregistering VLANs and can transmit only information about VLAN 1. If the registration
mode is set to forbidden for a trunk interface, the interface allows only VLAN 1 to pass
even if it is configured to allow all the VLANs to pass.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
gvrp registration { fixed | forbidden | normal }
The registration mode is set for the interface.
By default, the registration mode of a GVRP interface is normal.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
5 GVRP Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
154