Figure 9-16 Networking diagram for adding users to bridge groups
RouterB
User 5
Network
RouterA
User 1
User 4
User 2 User 3
VLAN 11
Perform the following steps on the user-side interface of the device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
bridge bridge-id
An interface is added to a bridge group.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
Ethernet sub-interfaces and GE sub-interfaces configured to terminate QinQ tags do not support
transparent bridging.
----End
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
369
To Next Page
Loading...
