Huawei eA660 Series - NAT;Routing Behind MS Settings; Bridge Settings

eA660 Series CPE
User Guide
4 Configuration Introduction
Issue 06 (2019-04-03)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
55
4.2 NAT /Routing Behind MS Settings
Prerequisites
Install EPC and CPE and commission them so that they are ready to be connected.
Configure the NAT Settings on EPC.
Background Information
NAT and Routing Behind MS are mutually exclusive features. On the CPE's web interface,
select Enable under NAT and click Submit to enable NAT or deselect Enable under NAT
and click Submit to enable Routing Behind MS.
Procedure
4 Log in to the WebUI, Please refer to the procedure 4.1
5 Go to Security > NAT Settings. Deselect Enable under NAT and click Submit to
enable Routing Behind MS.
Figure 4-1 Enabling NAT
----End
4.3 Bridge Settings
Prerequisites
Install EPC and CPE and commission them so that they are ready to be connected.
Configure the L2GRE tunnel settings on EPC.