eA660 Series CPE
User Guide
4 Configuration Introduction
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Install the DHCP server and CPE and commission them so that they are ready to be
connected.
Procedure
The DHCP clients connected to the CPE cannot obtain IP addresses from the DHCP server until DHCP
Relay and Routing Behind MS are both enabled.
8 Configure the DHCP server.
This document demonstrates how the DHCP server can be configured using Windows Server
2003.
a. On the computer, go to Control Panel > Management Tools > DHCP.
From the left panel, right-click Server Options, and choose New Scope Wizard.
Figure 4-3 Server Options > New Scope Wizard
b. Add a scope name.
Figure 4-4 Adding a scope name
c. Set the IP address range.
To Next Page
Loading...
