Huawei FusionServer Pro 2288X V5 - Checking Server Status; 7.4.4 Checking the Server

Step 6 Switch to the interface for changing the U-Boot password.
passwd
The command output is as follows:
Enter old password:
Step 7 Enter the old password.
The command output is as follows:
Enter new password:
Step 8 Enter a new password.
The command output is as follows:
Enter the new password again:
Step 9 Enter the new password again.
If the command output is as follows, the password has been changed:
. done
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... done
. done
Protected 1 sectors
password be changed successfully.
Step 10 Exit the U-Boot interface.
boot
----End
7.4.4 Checking the Server
Process
Check the server by performing the following operations:
FusionServer Pro 2288X V5 Server
User Guide 7 Installation and Conguration
Issue 04 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 102