Huawei LUNA2000-100KTL-M1 - C Resetting Password

C Resetting Password
Reset the password only when the AC power is supplied to the Smart PCS from
the power grid, diesel generator, or other voltage-source PCSs.
Step 1 Check that the AC and DC sides of the Smart PCS are both powered on, and
indicators
and are steady green or blinking slowly for more than 3 minutes.
Step 2 Turn o the AC switch between the AC side of the Smart PCS and the power grid
to power
o the AC side of the Smart PCS.
Step 3 Turn o the DC switch between the DC side of the Smart PCS and the ESS to
power
o the DC side of the Smart PCS.
Step 4 After the Smart PCS is powered o, complete the following operations within 4
minutes:
1. Turn on the AC switch and wait for about 90s or until the Smart PCS indicator
blinks.
2. Turn
o the AC switch, and wait for about 30s or until all LED indicators on
the Smart PCS panel turn o.
3. Turn on the AC switch and wait for about 90s or until the Smart PCS indicator
blinks.
Step 5 Log in to the app and reset the password within 10 minutes. Otherwise, all
parameters of the Smart PCS remain unchanged.
----End
NO TICE
You are advised to reset the password in the morning or at night when the solar
irradiance is low.
LUNA2000-100KTL-M1 Smart Power Control System
User Manual C Resetting Password
Issue 02 (2023-01-10) Copyright © Huawei Technologies Co., Ltd. 104