Huawei LUNA2000-100KTL-M1 - Page 58

Connection Mode
After the DC or AC side of the Smart PCS is powered on, the app can connect to
the Smart PCS through the WLAN module.
NO TICE
● The USB-Adapter2000-C WLAN module is supported.
● The mobile phone operating system must be Android 5.0 or later.
● Huawei and Samsung phones are recommended.
Figure 6-2 WLAN module connection
(A) Smart PCS
(B) WLAN module (C) Mobile phone
NO TICE
● If the AC switch between the Smart PCS and the power grid is turned on, but
the external switch on the DC side of the Smart PCS is turned
o, some
parameters cannot be set. Turn on the external switch on the DC side, and then
reset the parameters.
● If you change the grid code, some parameters may be restored to factory
defaults. After the grid code is changed, check whether any previously set
parameters are
aected.
● When the Smart PCS receives a reset, shutdown, or upgrade command, it may
disconnect from the grid,
aecting the energy yield.
● When the Smart PCS is powered on for the rst time, ensure that the
parameters are set correctly by professional personnel. Incorrect parameter
settings may result in noncompliance with the local standards and
aect the
normal operations of the device.
● Only professionals are allowed to set the grid, protection, feature, and power
adjustment parameters of the Smart PCS. If the grid, protection, and feature
parameters are set incorrectly, the Smart PCS may disconnect from the grid. If
the power adjustment parameters are set incorrectly, the Smart PCS may not
connect to the power grid as required. In these cases, the energy yield will be
aected.
LUNA2000-100KTL-M1 Smart Power Control System
User Manual 6 Power-On Commissioning
Issue 02 (2023-01-10) Copyright © Huawei Technologies Co., Ltd. 52