Huawei LUNA2000-100KTL-M1 - Page 70

No. Category Parameter Description Remarks
23 Threshold of
LVRT zero-
current mode
When Zero current due to
power grid fault is enabled,
if the power grid voltage is
less than the value of
Threshold of LVRT zero-
current mode during LVRT,
the zero current mode is
used. Otherwise, the mode
congured in LVRT mode is
used.
24 LVRT mode Sets LVRT mode. The options
are Zero-current mode,
Constant current mode,
Reactive power priority
mode, and Active power
priority mode.
25 LVRT
characteristic
curve
Species the low voltage ride-
through capability of the
device.
-
26 Grid voltage
protection shield
during VRT
Species whether to shield
the undervoltage protection
function during LVRT or
HVRT.
This parameter is
displayed when
LVRT or HVRT is set
to Enable.
27 VRT exit
hysteresis
threshold
Species the LVRT/HVRT
recovery threshold.
● This parameter is
displayed when
LVRT or HVRT is
set to Enable.
● LVRT recovery
threshold = LVRT
triggering
threshold + VRT
exit hysteresis
threshold
● HVRT recovery
threshold = HVRT
triggering
threshold + VRT
exit hysteresis
threshold
28 VRT active
current limiting
percentage
Species the percentage of
the maximum active current
to the rated current during
fault ride-through (FRT).
-
LUNA2000-100KTL-M1 Smart Power Control System
User Manual 6 Power-On Commissioning
Issue 02 (2023-01-10) Copyright © Huawei Technologies Co., Ltd. 64