Huawei LUNA2000-200KWH-2H1 - Communication Logic

Name Model/Specications Quantity Remarks
IMD DOLD RN5897.12/011, used
with the coupler DOLD
RP5898/61
1 Prepared by
the customer.
Do not connect
the
measurement
cable of the
IMD to circuit
breakers or
switches to
prevent the
measurement
loop from
being
disconnected.
DG Three-phase - Prepared by
the customer
(optional)
1.2 Communication Logic
One SACU or SmartLogger manages multiple ESSs, PCSs, and SUN2000s, one
meter, and one IMD to form an array. Intra-array:
● The SUN2000s communicate with the SACU or SmartLogger, the IMD
communicates with the SACU or SmartLogger, and the meter communicates
with the SACU or SmartLogger over RS485.
● The ESSs communicate with the SACU or SmartLogger over FE in star or chain
topology.
● The PCSs communicate with the SACU or SmartLogger over FE in star or ring
topology.
● Maximum communication distance of the SACU or SmartLogger:
– RS485: 1000 m
– FE: 100 m
Select either of the following topologies based on the quantities of ESSs and PCSs
in the array as well as the deployment of optical bers.
(Recommended) Typical Scenario 1: SmartLogger+ESS FE Star+PCS FE Star
Topology
In this scenario, the SmartLogger3000A is congured, and the customer needs to
prepare one switch (quantity of 10M/100M auto-sensing Ethernet ports ≥ 8). The
quantities of switches and Ethernet ports are congured based on the quantities
of ESSs and PCSs connected to the array.
Commercial and Industrial Microgrid Energy Storage
Solution
Quick Guide (With Third-Party Microgrid Central
Controller) 1 Solution Introduction
Issue 04 (2023-12-18) Copyright © Huawei Digital Power Technologies Co., Ltd. 9