Installation Manual
Quidway S5600 Series Ethernet Switches Chapter 5
Loading Boot ROM and Host Software
Huawei Technologies Proprietary
5-5
Figure 5-2 Console Port Configuration dialog box
Step 6: Click <Disconnect> to disconnect the HyperTerminal from the switch and then
click <Connect> to re-establish the connection, thus validating the baud rate setting.
Figure 5-3 <Disconnect> and <Connect> buttons
Note:
After changing terminal’s baud rate, you must disconnect and connect the terminal
emulation program to validate the new configuration.
Step 7: Press <Enter> to start program loading. The system displays the following
information:
Now please start transfer file with XMODEM protocol.
To Next Page
Loading...
