F47 On cable break
This function determines the unit’s response to a break in the cable, e.g. turn off
temperature control, or control to a second set-point.
F49 Unit name
This function displays the unit model number.
F50 Input password
Used only for Service. Contact Huber for further information.
F52 Factory default
This functions allows to reset the unit to the factory default.
F55 Degassing mode
Activating the degassing mode. Please see the section on Degassing an external closed
application.
F60 Information on the machine
In this function information on the machine can be obtained.
F61 X-Information (Service)
Xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
F68 Tempmove AIF – Tint
Xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
F69 Tempmove AIF Tproc
Xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
F70 Service increments
May only be used under directions of our Customer Support Team.
F71 Service functions
Used only for Service. Contact Huber for further information.
F72 Service temperature
Used only for Service. Contact Huber for further information.
F75 Cooling power man.
One can here set a constant cooling power. An automatic cooling power adjustment
does not take place.
F84 Slave address
Setting the unit´s BUS-address.
F85 Baudrate
Setting the Baudrate.
F86 Select RS232 / 485
Choosing the interface.
To Next Page
Loading...
