Decontamination / Repair
The user is responsible for making sure that there are no hazardous materials either in
or on the unit. The level of decontamination should be appropriate to the amount and
type of contaminants on the unit. The user should refer to the appropriate MSDS
information for advice.
The decontamination should be done BEFORE outside personnel come into contact with
the machine, and BEFORE the unit is sent out for repair or testing. The unit should be
clearly labelled that it has been decontaminated before it is sent.
We have prepared a document to simplify this process. This is available in the appendix,
and at our website www.huber-online.com.
Cleaning the surfaces
A normal steel cleaning spray is suitable for cleaning the stainless steel surfaces.
Painted areas should be carefully cleaned with a gentle detergent.
Plug contacts
Each socket has a protective cap belonging to it. If a connector is not required, then it
should be covered with this cap.
To Next Page
Loading...
