Huber CC508 - Com.G@te Menu Functions

43
Com.G@te menu
Here, the functions (analogue interface, RS232/RS485, ECS-Standby, POCO Alarm)
used in connection with an external control (e.g process control system “PCS”) are
listed.
COM.G@TE:
Analogue interface
RS232/RS485
ECS Standby
POCO Alarm
Return to main menu
ANALOGUE-INTERFACE:
Config. input
Config. output
Go back
DIGITAL INTERFACE:
Select RS232/485
Baud rate
Slave address (LAI)
Go back
USE EXTERNAL SIGNAL TO:
No action
Switch to 2nd setp.
2nd set-point selectiv
Internal / Process
Temp. contr. on/off
Enable machine
Go back
POCO ACTION:
OFF
Check act. value
External Alarm
Unipump/PCS
Control by RS232
Check process temp.
Unipump with echo
Programmerr
Check int. temp. abs.
Check proc. temp. abs.
Go back