Huber CC508 - Alarm and Warning Codes (Hard Alarms)

87
-143
-144
-148
-149
-150
-151
-152
The LT Pressostat has operated
The MT Pressostat has operated
Reporting contact of the pump
has tri
gg
ered
Phase Relay for the pump motor
has tri
gg
ered
HT Compressor gas outlet temp.
sensor fault
y
LT Compressor gas outlet temp.
fault
y
Thermal contact of the pump
has tri
gg
ered
Please contact us or our service partners
Please contact us or our service partners
Please contact us or our service partners
Right-hand (3 phase, 400V) rotation of the power supply
is not available.
Please connect to ri
g
ht-hand rotation.
Please contact us or our service partners
Please contact us or our service partners
Possible viscosity problem of the thermal fluid (viscosity is
too hi
g
h)
-153
-154
-155
-201
-202
-204
Temperature of the HT
com
p
ressor is too hi
g
h
Temperature of the NT
com
p
ressor too hi
g
h
HT compressor Oil pressure is
too low.
HT compressor gas outlet
tem
p
erature to hi
g
h.
LT compressor gas outlet
tem
p
erature to hi
g
h.
Motor protection switch has
tri
g
g
ered b
y
Over-tem
p
erature
Please contact us or our service partners
Please contact us or our service partners
Please contact us or our service partners
Please contact us or our service partners
Please contact us or our service partners
Please contact us or our service partners
-215
-216
-1027
-1029
-2048
Motor protection switch has
tri
gg
ered
b
y
OT in Main-heatin
g
.
Motor protection switch has
tri
gg
ered
b
y
OT in Fine-heatin
g
No pressure increase since pump
start. Is
p
um
p
dr
y
?
Level error: Liquid level too low
Internal actual value has
exceeded alarm tem
p
erature
Please contact us or our service partners
Please contact us or our service partners
Possibly insufficient thermal fluid in the circuit. Fill in
thermal fluid and air-
p
ur
g
e.
Possibly insufficient thermal fluid in the circuit. Fill in
thermal fluid and air-
p
ur
g
e.
Please contact us or our service partners