Humminbird ONIX Opeartion Manual

126
Turn on/off Contour Mode
Contour Mode controls how the water column is displayed in the Mosaic. The location of a target in the Mosaic is influenced by the
Contour Mode setting. For more information, see Customize the Side Imaging View: Turn on/off Contour Mode.
When Contour Mode turned off, the water column is displayed on the view. The location of a target on the display is based on the
slant range to the target.
When Contour Mode is turned on, the bottom is graphed at a constant point on the display, regardless of changes in depth. The Side
Imaging beams are divided by a vertical line. The water column is removed from the view, which allows the display to show targets
at their linear horizontal distance. The location of a target may be easier to interpret when the water column is removed.
Turn on/off Contour Mode
1. From the Mosaic menu, select Contour Mode.
2. Tap the on/off button, or press the ENTER key, to turn it on/off.
Off: The water column is displayed.
On: The water column is hidden.
Mosaic

Humminbird ONIX Specifications

General

Networking	Ethernet
Waterproof Rating	IPX7
Waypoints	3000
Power Output	500W (RMS)
Frequency	50/83/200 kHz
GPS Receiver	Internal