2
Installation Instructions
Base Placement
1. Remove the bolts securing the base assembly to the pallet, using a 1/2 inch wrench or socket.
SECURING BOLTS
2. Remove the base assembly from the pallet.
CAUTION: Use proper lifting techniques when moving the base assembly.
Do NOT lift by weight tray.
3. Position the base near the intended location. Refer to “Placement,” page 1.
4. Using a 5/16 inch Allen wrench, loosen four bolts securing the display panel to the balancer.
BOLT ACCESS
HOLES
DISPLAY PANEL IN
HORIZONTAL
SHIPPING POSITION
5. Slide the display panel to the left, then away from the balancer slightly to clear the keyhole openings over the
loosened bolts. Rotate the display panel 90 degrees clockwise to the upright position. Slide the display panel
down over the bolts and retighten the bolts.
DISPLAY PANEL IN
ERTICAL OPERATION
POSITION
To Next Page
Loading...
