8
Belt Break-In:
1. Remove four screws securing the spindle drive belt cover to the base assembly on the right side of the
DSP9600/9100.
SPINDLE DRIVE
BELT COVER
2. Check belt tension:
a.) Remove the weight tray from the balancer (if not done already).
b.) Position end of indicator flush with scale of belt tension tool.
c.) Place index finger inside rubber finger strap of belt tension tool.
d.) Position belt tension tool on horizontal section of belt between motor and spindle.
e.) Push down on belt tension tool until the tool clicks.
f.) Read belt tension tool where top edge of the arm crosses the scale (refer to illustration).
g.) Set belt tension to 90 lbs., ± 5 lbs. (41 kg., ± 2 kg.) Check 30 days after installation. Reset if
necessary.
To Next Page
Loading...
