9
3. Adjust belt tension:
a.) Loosen four motor mount bolts.
b.) Position a 1/2 inch drive ratchet into the square hole in the adjusting cam.
c.) Increase belt tension by pulling the ratchet in a clockwise rotation.
d.) Tighten four motor mount bolts.
e.) Recheck belt tension and adjust as needed.
DJUSTING CAM
MOTOR MOUNT
BOLT
f.) Position spindle drive belt cover to housing assembly and secure using four screws
previously removed.
Install Weight Tray:
1. On DSP9600, remove hose from optional Inflation Station™ holder and drape over spindle shaft.
2. Slide the Inner Dataset® Arm out past the hub. Tilt the arm so that it catches on the hub. The hub will prevent
the arm from returning to the “home” position.
3. Place the weight tray on the DSP9600/9100 base assembly.
NOTE: When installing the weight tray, it may be necessary to lift up on the rear of
the weight tray, while pushing the weight tray backward into position.
4. Secure the weight anvil to weight tray with two socket head bolts previously removed.
5. Secure the weight tray to the base with the Phillips head screw previously removed from the weight tray’s
front left corner.
6. Place the Inner Dataset® Arm back into its home position.
7. Place the hose back into the Inflation Station™ holder, if so equipped.
8. Connect the electrical power cord to the AC power source.
Weight Tray Decal Installation:
Place the weight tray decals, 128-421-2, on the indentations above the weight tray pockets.
Verifying the Hub and Shaft Installation:
Using a dial indicator, measure hub face and shaft runout. Runout on the hub face should not exceed 0.0015
inch. Runout on the shaft should not exceed 0.0015 inch. If runout exceeds these limits, replace the hub/shaft
assembly.
To Next Page
Loading...
