Hunter DSP9100 - Install Optional Wheel Lift

14
8. Store the calibration weight in the threaded hole on the control panel support.
CONTROL PANEL
SUPPORT
CALIBRATION
WEIGHT
CONTROL PANEL
Install Optional Wheel Lift (DSP9600 only):
1. If “ON,” turn the DSP9600 Balancer “OFF.”
2. Disconnect the electrical power cord from the AC power source.
3. Disconnect air supply hose from the shop’s air supply line.
4. If present, remove tie wraps securing attachment blocks, 121-205-2, to lift mechanism arms.
A
TTACHMENT
BLOCKS,
121-205-2
LIFT MECHANISM
ARMS
5. Remove packaging from beam, 118-649-1-002, and from hardware.
6. Beam must be rotated so that the top of the beam is toward the front of the balancer. After the mounting plate
is inside of the tub, the beam should be rotated 90 degrees clockwise.
TUB
MOUNTING
PLATE
TOP SIDE
OF BEAM