Hunter DSP9100 - Remove Weight Tray; Install Safety Hood

3
Remove Weight Tray:
1. Remove the two Allen head bolts that secure the weight anvil to the weight tray, using a 5/32 inch Allen
wrench.
INFLATION
STATION
WEIGHT ANVIL
SOCKET HEAD
BOLTS
PHILLIPS HEAD
SCREW
2. Remove the Phillips head screw from the front left corner of the weight tray.
3. On DSP9600, remove hose from optional Inflation Station™ holder and drape over spindle shaft.
4. Extend the Inner Dataset® Arm out past the face of the hub. Rotate the arm so that it catches on the hub face
to prevent the arm from returning to the “home” position.
5. Lift the weight tray up and forward off the base.
6. Place the Inner Dataset® Arm back into its home position.
7. Place the hose back into the optional Inflation Station™ holder.
Install Safety Hood:
NOTE: It is recommended to use an assistant during this portion of installation.
1. Apply a coating of silicone or Teflon grease to the hood shaft. The hood shaft is the bearing surface of the
hood assembly.
2. Place the thin steel washer, 77-248-2, on the hood shaft.
3. Slide the hood assembly, 69-1026-1, onto the shaft.
4. Verify that the plastic bushings on each end of the hood shaft are flush. If they are not flush, a soft head
hammer may be used to adjust the bushings.