5
3. Verify that the hood is in the raised position and attach the spring to the stud found on the hood spring
attachment bracket.
HOOD SPRING HOOK,
216-43-2
HOOD SPRING,
98-303-2
Install Optional Outer Dataset® Arm (DSP9600 only):
1. Route the one wire attached to the Outer Dataset® Arm assembly, 103-131-1, through the hood shaft.
2. Using a 7/32 inch Allen wrench, remove the Allen screw from the black portion of the Outer Dataset® Arm.
3. Position the black portion of the Outer Dataset® Arm into the shaft.
4. Rotate the black bushing on the Outer Dataset® Arm until it aligns with the alignment hole in the shaft.
5. Reinstall the 3/8 inch SBHCS (Allen head) screw, 74-93-2, into the alignment hole and secure.
6. Verify that the wiring is taut through the hollow shaft.
7. Route the wire through the grommet in the rear of the machine.
WIRE FROM
DATASET® ARM
HOLLOW SHAFT
To Next Page
Loading...
