Hunter DSP9100 - Install Safety Hood Spring Mounting Bracket; Install Hood Spring

4
5. Loosen the two RHMS (Phillips head) screws, 75-35-2, that connects both halves of the hood tube clamp,
12-157-2. Slide the hood tube clamp onto the shaft. Rotate the clamp so that the screws are located on the
shaft in the 6 o’clock and 12 o’clock positions. Tighten the two screws.
HOOD TUBE CLAMP,
12-157-2
PLASTIC BUSHING
HOOD ASSEMBLY,
69-1026-1
ON DSP9100,
LOCATE PLUG
53-147-2
HERE
NOTE: For DSP9100 Balancers only, insert plug, 53-147-2, to the end of the shaft
supporting the hood assembly.
Install Safety Hood Spring Mounting Bracket:
1. Attach hood spring attachment bracket, 14-986-1-002, to the bracket support located on the hood, with a 3/8
inch bolt, 74-59-2.
HOOD SPRING
ATTACHMENT
BRACKET,
14-986-1-002
3/8 INCH BOLT,
74-59-2
2. Firmly tighten hood spring attachment bracket bolt.
Install Hood Spring:
1. Position the hood spring hook, 216-43-2, through the eyelet of the hood spring, 98-303-2.
2. Position the hood spring hook into the mounting holes located near the bottom of the rear of the balancer.