7
10. Secure excess wires to the rear of the balancer by opening a plastic wire clamp and positioning the excess
wire inside.
PLASTIC WIRE
CLAMP
Install Storage Pegs:
1. Verify that the Keps nut, 76-159-2, is on the threaded surface of the storage peg. Verify that the serrated
surface of the Keps nut faces the balancer.
2. Thread the storage peg, 63-85-2, into a hole on the left-hand side of the balancer.
3. Position the peg so it is angled up and hold the peg in place while you secure the Keps nut with a 9/16 inch
wrench.
4. Repeat steps one through three for additional storage pegs.
CAUTION: Do not allow the pegs to protrude inside the balancer and contact the
balance frame structure.
STORAGE PEG
THREADS
BALANCER
FRAME
To Next Page
Loading...
