15
NOTE: Orientation of the beam when slid into the balancer tub is very important.
If the beam is inserted into the balancer tub incorrectly, it cannot be rotated
into the proper position.
7. With the beam rotated so that the mounting plate is horizontal, secure the beam to the lift mechanism arms
with the four bolts and lock washers provided. Ensure that arms are fully seated against the attachment
blocks before tightening.
LIFT MECHANISM
ARMS
TOP SIDE
OF BEAM
NOTE: The bolts should be finger-tightened only at this time.
8. Connect air supply hose to the shop’s 90-145 psi (6.21-10.00 bar) air supply line.
9. Connect the electrical power cord to the AC power source.
10. Turn the DSP9600 Balancer “ON.”
11. Move the lift control handle (located on the front of the DSP9600) upward to move the lift approximately
halfway up in its travel.
DOWN
UP
LIFT CONTROL
HANDLE
12. Remove the nut securing the trolley bolt to the beam, then remove the bolt. Refer to photo in step 14 for
location of trolley bolt and nut.
To Next Page
Loading...
