Hunter PRO-C P2C Series

17
All stations operate in numerical order. Only
one program start time is required to activate a
watering program.
If a program has all four start times turned o,
then that program is o (all other program details
are retained). Because there are no start times,
there will be no watering with that program.
Note
Built on Innovation
®
Setting Program Start Times
1. Turn the dial to the START TIMES position.
2. Press the PRG button to select A, B, or C.
3. Use the + and - buttons to change the start time.
(Advances in 15-minute increments.) One start time will
activate all stations sequentially in that program.
4. Press the → button to add another start time or the PRG
button for the next program.
Eliminating a Program Start Time
With the dial set to the START TIMES position, push the +
and - buttons until you reach 12:00 am (midnight). From this
position, push the - button once to reach the OFF position.