Hunter TCX50H Series - Operation During Use and Pedal Configurations

Operation Instructions for TCX50H Tire Charger
17
1.8 During Use
In the event you hear any strange noise or feel unusual vibrations, if a component system
is not operating properly or if there is anything unusual at all, stop using the machine
immediately.
• Identify the cause and take any necessary remedial action.
• Contact your supervisor if necessary.
Never allow any bystander to be within 20 feet of the machine during operation.
To stop the machine in an emergency:
• disconnect the power supply plug;
• cut off the compressed air supply network by disconnecting the shut-off valve (snap
coupling).
1.9 Control Pedal Congurations
Avoid unintended machine movement and personal injury.
Pay close attention to the conguration of your machine.
WARNING
Throughout this manual, control pedals are referred to by the associated symbol.
The PowerOut system provides bead breaking controls on the handle for convenience,
particularly with larger diameter assemblies.
1.10 Wheel Rotation Pedal
Step down on the rotation pedal to rotate the wheel clockwise.
Lift up on the pedal to rotate the wheel counterclockwise.