Operation Instructions for TCX50H Tire Charger
45
7. Operate the BPS control lever to lower the arm and put pressure on the tire until the bead
is in the drop center of the rim. This prevents the bead from being excessively taut and
allows it to rise more easily on the toolhead.
8. Lift the arm of the BPS and swing it outwards to free the work surface, then turn the table
top to allow the outer bead to slip out.
If the sidewall is so rigid that the bead is unable to position in the drop center, the
operation can be facilitated by using the second BPS roller. Mount the second roller
on the BPS, positioning it to the left of the BPS roller, halfway between the BPS
roller and the toolhead.
NOTICE
Breaking the Inner Bead
If the inner bead has re-seated, use the tire lifting disc to loosen it. Follow these steps:
1. Mount the tire lifting disc on to the lower arm holder and lock it in place with the pin.
2. Position the tire lifting disc under the tire, making sure that it is near the edge of the rim.
3. Position the bead lever in the hole on the tire lifting disc arm and hold it to keep the tire
lifting disc pressed against the tire.
4. Rotate the turntable clockwise simultaneously raising the tire lifting disc up, with the
control lever until the bead-loosening procedure is completed. (Thoroughly lubricate the
inner bead before removing it).
To Next Page
Loading...
