Operation Instructions for TCX50H Tire Charger
48
Mounting the Outer Bead
1. If the wheel has an internal sensor, position it directly across from the toolhead.
2. Mount the second roller arm on the BPS.
3. Position both rollers as shown below.
4. Lower the arms until the outer bead is in the drop center and under the hooked section of
the toolhead.
5. Turn the table top clockwise, the BPS roller will turn along with the tire, allowing the outer
bead to slip into the rim, while the second roller will remain at a standstill in its position,
preventing the bead from slipping out again.
To Next Page
Loading...
