Operation Instructions for TCX50H Tire Charger
44
3. Move the control lever downwards until the roller presses on the tire and the bead moves
a few millimeters away from the rim, then rotate the turntable clockwise. The swivel arm
will turn with the tire until it comes against the end travel stop. At this point the roller will
begin to loosen the top bead on the tire. (When the top bead has been pushed into the
drop center, the operator can lubricate the bead and the rim thoroughly to facilitate the
subsequent demounting stages).
4. When the operation has been completed, lift off the roller, move the Bead Press System
away from the turntable, and begin the demounting operations.
Demounting the Outer Bead
1. Move the toolhead to the work position. If the wheel has a sensor, turn the table top until
this sensor is lined up with the toolhead.
2. Move the arm of the BPS to the work position.
3. Move the bead presser roller out to the tire and to the right of the toolhead.
4. Operate the BPS control lever in order to press on the tire and create sufcient space to
correctly position the toolhead and subsequently insert the bead lifting lever.
5. Lock the toolhead in place and insert the bead lifting lever.
6. Operate the BPS control lever and lift the arm, then turn it and move the bead presser
roller opposite the toolhead.
To Next Page
Loading...
