Hunter TCX50H Series - 6.2 Maintenance and Replacement Parts

Operation Instructions for TCX50H Tire Charger
52
Maintenance Schedule Perform the Following Maintenance
Daily
Drain condensation from pressure regulator
reservoir by pressing in on the tting located on
the bottom of the regulator.
Check for worn or damaged rubber and nylon
components that should be replaced to prevent
damage from occurring. Replace worn parts as
needed (tool supports, rubber pads, lever protector
sleeve and mount/demount head).
Clean all areas that contact rims or tires to prevent
possible scratching to rim.
Weekly
Clean tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed
air, which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator/oiler.
Periodically
Rell the pressure regulator/oiler using only Hunter
Lubri-Oil, 148-133-2, as needed. Petroleum-
based oils should never be used in the oiler
and may void all warranties.
Adjust the oiler to release one drop of oil every
three rotations of the clamping table by adjusting
the screw on top.
Check for loose bolts and tighten per
specications.
6.2 Maintenance and Replacement Parts
NAME NUMBER
Safety Goggles 179-15-2
Brush RP6-1506
Mounting Paste RP6-3784
Polymer Mount/Demount Head RP11-3314813
Hand Held Bead Lever - straight RP11-3009516
Bead Lever Protector Sleeve (HM) RP6-0326
Bead Lever Protector Sleeve (Std) (4) RP11-8-11400098
High Grip Jaw Protection Kit (2 sets - 8 covers) RP11-8-11100358
Steel Head Inserts (10 sets - 20 covers) RP11-8-11400096
Clamping Jaw Extensions AR46 (4) RP11-8-11400276