Operation Instructions for TCX50H Tire Charger
49
Sensor Inspection/Replacement
If the wheel has an internal sensor, the BPS used with the second roller will allow you to
inspect and replace the actual sensor itself without having to remove the tire from the rim.
Only work on the sensor after having consulted the operation and maintenance
manuals of the vehicle and sensor itself.
NOTICE
Proceed in the following way:
1. Break the bead as described in Section 2.1, Bead Breaking, page 22.
2. Clamp the rim on the table top and position the sensor at 5:00 o’clock (use vertical post as
reference - 12:00 o’clock).
3. Move the arm of the BPS to the work position with the roller at 7:00 o’clock.
4. Mount the BPS second roller and position it at 4:00 o’clock.
5. Using the BPS control lever, slowly lower the rollers until you have enough space to check
or replace the sensor. Take the utmost care to prevent the bead from touching the sensor
during this operation.
6. After having terminated the operations, slowly lift the rollers until the bead has passed
over the sensors.
To Next Page
Loading...
