Operation Instructions for TCX50H Tire Charger
35
Figure below is a summary of the desired end result.
17-18”
For Tilting Plastic Heads
Figure below is a summary of the desired end result.
The head will adjust itself to each rim diameter, due to its tilting feature.
TILTING
Set Position of Plastic Mount/Demount Head on Hex Shaft
1- Fit the head on the hexagonal shaft.
2- Fully tighten the head retaining bolt being sure to insert the relevant washer and bushing.
HEAD
RETAINING
BOLT
SPACERS
BUSHING
WASHER
ADJUSTMENT
BOLTS
HEX SHAFT
PIN
ADJUSTMENT
BOLTS
HEAD
RETAINING
BOLT
3- Fully tighten the adjustment bolts being sure to insert the two relevant spacers.
To Next Page
Loading...
